<input id="uauy4"></input> Foshan Steel: Steel construction door optimal planning methods and procedures
Lightweight steel door frame structure with low cost, light weight, easy installation, short construction period, etc., so the rapid development in recent years, in industrial plants has been more widely used. However, in practice in project planning, especially the steel rod structure is constructed of steel portal frame variable cross-sectional dimension need to go through multiple spreadsheets in order to determine, together with the experience of the current planners planning such a structure is not rich, so the plan is not efficient , the rod cross-sectional dimension of choice is also quite reasonable, simple structure resulting in all the various stress uneven bars, not only economic indicators is not ideal, and safety of the entire structure is not high, even some projects will be too much stress the individual rods planning exceed the material strength. Even stress after plastic deformation of steel construction material considerations redistribution, it is still possible to make the whole structure of the existence of certain security risks.
When optimizing policy making steel gantry structure plan, should be under the premise of ensuring safety construction, so that the amount of steel structure of most provinces, the cost to a minimum. This is what we used to optimize the principle of optimal planning method. In a useful planning, the door frame steel structure of steel consumption and cost structure in turn resolution cross-sectional dimension of the rod, the. Therefore, our optimization approach can be directly reduced to how to select the economically reasonable cross-sectional dimension, so that it meet the strength, stiffness and stability needs of the premise, the minimum cross-sectional area.
Optimization methods and optimization of steel truss structure similar to the mast {TodayHot} steel structure optimization method also uses the asymptotic full stress method, which bars the door frame steel structure after several computational analysis to select amend its cross-sectional dimension, it or as close as possible to achieve the full stress state, cross-sectional dimension of the rod until the entire door frame steel structure without amendments so far, so that the door frame steel structure of the minimum amount of steel in order to achieve the lowest cost optimization approach. Member cross-sectional dimension of the amendment, which is the cross-sectional dimension of the optimization, the method is chosen seeks its cross-sectional dimension in the plane, the two directions of the plane of maximum flexural resistance torque, while its cross-sectional area of the smallest, namely under external loads, Select the cross-sectional dimension of both to be able to meet the strength, stability, strength of demand planning checking the component materials, but also to make the most amount of material province. Specific optimization method is omitted here.
Steel door frame structure optimization analysis based optimization method used steps and constraints, optimization analysis step gantry steel structure is as follows: Step 1: Determine the door architecture made an initial cross-sectional dimension members, the software is generally made on the basis of cross-gate architecture OK, but also by the planning staff to determine; the second step: making door architecture mechanical analysis using finite element variable cross-section rods various operating conditions, load combinations, strength and stability checking; third step: According to the practice of loading effect, each kinds constraints, using full stress-section optimization methods to re-optimize the selection gate structure made each rod cross-sectional dimension; more than second and third step can be repeated cycles, each cycle is complete optimization options, until the selected cross-sectional dimension of the a cross-sectional dimension entirely consistent so far. Step four: Checking door architecture made beams, columns, and each point needs to meet the relevant norms, such as the press does not meet a certain share of the adjustment parameter optimization sectional dimension reference section is full of stress optimization method, and then repeat the second, three-step cycle optimization, until the points gantry steel structure to meet the requirements of all components of the deformation is demand.
Realize full stress optimized cross-sectional dimension, the cycles are more generally more than 10 times before convergence is achieved mast stiffness to meet the needs of cross-sectional dimension distortion optimization less frequently, usually 1-3 times to meet the demand.
QR code of public account
<input id="uauy4"></input>